Cerberus tank accessories
If you do not have a hex wrench that size use a metric bolt. tTghten a nut on it and you can use a rench. Option use a bolt and vise grip or weld the bolt to a socket.
this is the only axle socket tool that will actually fit your mv agusta axle nut! Contrary to what you may have been told a standard 55mm socket will not fit properly on your MV's Axle nut. This is because the large axle nuts on all MV's have a special 2mm taper.
Dabada ayuu gacanta iga saaray
Apr 04, 2012 · The other tool is a 19mm, (3/4″), hex head, (Allen wrench), socket. The hex head wrench costs around $18 – $20 at a local Napa store. The left side of the swingarm pivot axle is a 15/16″ nut which is fairly straightforward. On the right side of the bike, the pivot axle locking nut and the pivot axle itself, have to be removed.
Using the proper size socket and torque wrench, tighten the NEW wheel drive shaft nut to: For Style 1, 330 Y (244 lb ft) For Style 2, First Pass: 50 Y (37 lb ft) For Style 2, Final Pass: plus 60 degrees. Using appropriate tools (3), stake the wheel drive shaft nut collar into the slot on the wheel drive shaft.
Chrome web store mobile
Feb 22, 2009 · The Rear axle nut is 27mm, It is difficult to get to with the exhaust on, here is what I did, I took a 27mm socket cut 1/4" off the end, then took a piece of 1/2 bar, welded a washer that fit inside the sockett to the end of the bar so it slides in and out of the socket, as you push the socket on the 1/2 bar slides out allowing you to get a 1/2" wrench on the bar stock and remove the nut.
ABOUT THIS MANUAL ABbout Thies Manufore al You Begin Read this manual carefully, providing extra attention to its explanations and instructions. To ensure safe, continuous,