• -Fuel-it Port Injection -JB4-Dodson clutches upgrade Dyno results: 703whp / 737wtq-12th F82 S55 M4 build by Caribbean Autowerks Mods:-PureTurbos stage 2-FBO-Fuel-it Port Injection -JB4-EOS watercooler-E85 fuel Dyno results: 722whp / 712wtq-13th F80 S55 M3 build by AutohausFrankurt Mods:-PureTurbos stage 2-Fbo-91 oct only
  • This is a direct replacement Fuel Pump for the BMW FXX N57N / N57Z Series Engines. The pump is capable of delivering significantly more fuel compared to the factory L75 pump. This pump is capable of around 2200 BAR rail pressure but must be coupled with suitable injectors to run this pressure.
  • I thought I'd jump in on this E36 M3 supercharger thread since I just got one from Turner Motorsports... > Previously, Charles Quarton <chazq_at_ix.netcom.com> stated: > The Turner unit uses higher fuel pressure to achieve a higher fuel > injection. This technology lacks the precision of the higher capacity > injector with electronic control.
  • Feb 14, 2013 · The guys over at Active Autowerke know that nobody buys an M3 because they like limits. The American company build a kit that takes the E36 M3 from 286 HP to 360 HP with the help of a HKS GTS8550 ...
  • ViVA Performance recommends using this fuel injector when upgrading to the K16 Turbocharger Unit. Vehicle Fitment. 2004.5 - 2011 S40/V50 T5 FWD/AWD. 2007 - 2011 C30 T5 FWD. 2006 - 2011 C70 T5 FWD. (All tests conducted using the industry standard Heptane).
  • The combination will give you a compression ratio of around 11.25:1 according to my estimates. With M3 cams (ether 3.0L or 3.2L) the engine dynos at around 240-250 crankshaft horsepower with stock injectors. Upgrading injectors will probably make even more power because the engine leans out and stops making power after 6200 rpm.
  • The BMW M54 is a naturally aspirated straight-6 petrol engine produced from 2000 to 2006. It was released in the E53 X5 and is the replacement for the M52 engine. The S54 is the equivalent high performance engine, used in the E46 M3, the Z3 M Coupé/Roadster and the E85 Z4 M.
  • The stage 2 upgrade also includes an new high performance fuel pump to help deliver the necessary fuel. With the reliability and performance of an intercooled system along with our perfectly tuned software this system is a must for the true enthusiast looking to bring their M3 to new heights. Key Features: Rotrex C38-81 Supercharger

Information taken directly from an existing classified source and stated verbatim

Stage 2 - E36 M3 Turner Motorsport / Conforti / Euro Intake Kit with 24LB Fuel Injectors A fantastic upgrade package for the 1995-1999 E36 M3 3.0 or 3.2 with OBD-I! This special package combines some of our most popular upgrades for a lot of horsepower and less money!!!
The original 1jzgte injectors flow 380cc, and they were upgraded to the 3sgte injectors out of a 3rd gen MR2 which flow 540cc. Many people swap in the 550cc out of the 2jzgte, however a resistor pack needs to be wired in...

Bumble said i had a match but itpercent27s not there

**Requires Built Motor Internals ** RACE FUEL ONLY (HP results will vary if this is for an M3 vs a 325 or 328 motor E36) Running at +30 psi Built Motor. up to 700whp = 820 motor hp
Bmw M30 Turbo Kit

357 vs 44 mag lever action

I'm looking at new bigger injectors but I'm not sure if I have to upgrade anything else for new injectors to work or will 36lb injectors fit on my stock fuel rails. Will that work or will I need other accessories for it to fit properly and run well?
The BMW S65 is a naturally aspirated V8 petrol engine which was produced from 2007–2013. Its main use was in the BMW M3 (where it replaced the BMW S54 straight-six engine). ). There is no direct replacement for the S65, since the following generation of M3 switched to a turbocharged straight-six engine (the BMW S